Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Bloomington, MN

Roll-Up Door Repair in Bloomington, MN

Sheet roll-up doors for storage units, sheds and warehouses repaired. Typical cost $150-$600.

Our roll-up door repair service in Bloomington, MN comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Sheet roll-up doors for storage units, sheds and warehouses repaired.

Is it time for roll-up door repair?

  • The door is hard to lift or won't stay up
  • A dented or creased curtain
  • The latch won't lock
  • The door comes out of its guides

Why this happens

  • Loss of spring tension
  • Impact damage
  • Worn latches and stops

What you can check yourself

  • Check whether the stops at the top of the guides are in place.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle roll-up door repair

  1. Inspect the curtain, guides and drum
  2. Adjust or replace the springs
  3. Repair the curtain or replace the door
  4. Replace latches and stops
  5. Test it

How much does roll-up door repair cost?

$150-$600Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size, gauge and cycle rating
  • Operator type and controls
  • Parts availability for your model
  • Lift equipment and after-hours access

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Local roll-up door repair for Bloomington, MN

Road salt and meltwater dripping off vehicles rust the bottom of tracks, cables and roller stems, which is why cable and roller failures in Minnesota usually start at floor level.

Technicians serve all of Bloomington (ZIP codes 55420, 55431 and 55435), plus Richfield (3 mi), Edina (4.2 mi), Savage (4.7 mi) and Burnsville (5.1 mi). Call (833) 435-8883 to book a visit in Bloomington.

Roll-Up Door Repair: frequently asked questions

How much does roll-up door repair cost in Bloomington, MN?

Roll-Up Door Repair typically costs $150-$600 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do roll-up door repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is roll-up door repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Minnesota or Bloomington requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my commercial door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the commercial door is near the end of its life, replace it. Commercial doors are rated by cycles. If the door has reached its rated cycle life, has several damaged sections, or parts are no longer made, replacing it is often cheaper over the next few years. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Bloomington, MN

Hörmann Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Haas Door Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Screw Drive Opener Repair

Screw-drive openers cleaned, lubricated and repaired.

Typical $125-$350

Raynor Remote & Keypad Programming

Remotes, keypads and car buttons matched and programmed to your opener.

Typical $50-$150

Craftsman Smart Garage Door Opener Setup

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $100-$900

Emergency Garage Door Repair

Priority service when your door is stuck open, off track or won't close.

Typical $175-$500

Windsor Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Moore-O-Matic Garage Door Sensor Repair

Moore-O-Matic openers are no longer made. We can often keep one running with available parts, or recommend a modern replacement.

Typical $100-$250

Opener Gear & Sprocket Replacement

Stripped drive gears replaced so the motor moves the door again.

Typical $125-$275

Richards-Wilcox Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Cornell Cookson Commercial Door Operator Repair

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $300-$1,200

Cornell Cookson Rolling Steel Door Repair

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $300-$1,500

Garage door stuck, noisy or broken?

Talk to a garage door technician in Bloomington, MN now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote